CHAINKIT PREMIUM ALU MOTO TM 80/85 BIG WHEEL 01-

"|Schrems premium chain kit - you are on the right side. This is chainkit we fabrikate with our 35 years of experience, taking into account its purpose and power of the machine, for the extreme driving. Replace the OEM quality including Schrems chain spray (the spray for the kit.).

Note: Special requirements accepted as other chain type, other chain length, different number of teeth, colour, material etc sprocket Just in the shopping cart / checkout in note to specify your wishes exactly. Should this process result in a higher price, you get a quote by email or telephone.

|"

If you make an order without specification, we will delivery the normal quality. If you use a Chain kit or Chain lower Quality, than the manufacturer recommended, you can cancel your warranty. Standard number of Teeth of Sprockets is available. Alternative are 1-2 Weeks delivery. Chain, with Chain clip is weaker than endless or rivets Chain. For O-Ring /And X-Ring we recommend the rivet to use. Please care the Recommendation of manufacturer. Pease double-check with our Catalogue, if you choose the right Chain and connecting element. Wrong choice may be destroy your bike and your health. Please use the clips till 600 cc and max 50PS only. See the using up of the chain guide. The defect chain guide can destroy the O- or X-Rings, the chain can split or the chain can destroy the swing-arm. Remove the chain clip of your old chain. In case of a closed or riveted chain you use appropriate chain separation equipment to open and the chain. We recommend in this case sanding the supernatant heads off of the rivet pins in the place, where you want to separate the chain, first with an angle sander - the separation equipment relieves. Remove then the old chain. Install now your new chain and connect the two ends of the chain with the new chain clip greased before. With O-ring /X-Ring chains make sure you please that all gaskets sit at the intended positions and are also greased. With the clip the closed side of the tie-clip must always point to direction of travel. Use for rivet locks only for it intended tools. Pay attention thereby to the operating instructions of the equipment. The CZ chains are manufactured after the new standards and corresponds the ISO9001 standard. Except material defects or wrong the individual components, extract themselves all further cases of our responsibility build up: normal wear, wrong assembly, bad maintenance, change of the achievement at the motorcycle, thereby conditioned multi-wear or running employment. Use for the running employment only for it produced chains. We advise you gladly.